Mojo 2 current draw ?

[fumbles]

Hi Yeo,
setting up my Mojo2 and have a few questions,
1 - what is the approximate current draw with full complement of regs ?,
2 - the PH 5.4 reg has 3 legs but description on site says only connect O & G ?
(I initially did not notice and connected all 3 but reg got very hot very quickly and I powered off and noted the above, so disconnected the "I" lead from reg PCB)
3 - 12v Audioslave seems to be getting very hot and have only tried it with 18v in yet, bit wary of going to 24v as I intended.
tks,
Tony G

[yeo]

hi tony

not more than 100ma.

paul made a mistake when building this batch. it's supposed to be just a shunt regulator but he included a ccs. so when you bypass the I, you bypass the ccs and use paul's ccs2 which is a much better ccs than the one onboard the 5v regulator.

yes, it's quite hot. put a small heatsink on it. be careful that it doesn't touch anything else!

yeo

[fumbles]

Thanks Yeo,
will put a heatsink on it then, I already noted that the back is live output.
Will try a ram chip heatsink with sticky back.
Sounding pretty darn good already.
regards,
Tony G