DIY Chassis - Made To Measure!

[cyliew]

Hey KenC,

You cannot expect every diyer as aggressive as you. ;)

RedC,

Please consider posting a low profile photo. With height at about 50mm or 2" which is nice as a tube amp chassis.

Cheers,
Liew

[RedC]

Yeo,
Thanks for the shoulder  ;D

On the contrary. I only wanted to utilize a lower labour cost available.
The Bender is semi-retired who dont mind doing this to make a few extra bucks.
Btw, Its 1.5mm thk.

D. Bomoh,
As I dont have any extra piece of alu sheet lying in his workshop. I'll try to figure something out, but first, give me your exact dimensions.

Goldenear,
You too. Please state which will be the 'open side'. Side where side plates are fitted.

Cheers,
RedC.

[Goldenear]

Hi,  

i'm suggesting 2 x 17 x 10 inch.If i'm not wrong.Need to double check


Kenneth